China wholesale Stamping Factory – Hot Runner Plastic Injection Mold – DT-TOTALSOLUTIONS
China wholesale Stamping Factory – Hot Runner Plastic Injection Mold – DT-TOTALSOLUTIONS Detail:
DT-TotalSolutions has very rich experience in designing and building molds in hot runner system.
The advantage by using hot runner:
– For some complex part and part of too thick or too thin, hot runner system is a must to make sure plastic flow run in full.
– For precision small parts in multi-cavity, hot runner system is also a must both to ensure full shot and save plastic material therefore to save the molding production cost.
– By using hot runner system, molding cycle time can be reduced by around 30% or more. This means your daily molding output can be greatly increased.
– By using complete hot runner system, plastic material wastage is 0. This is a very considerable cost especially for some special material which are very expensive.
– For some special plastic material with poor flow character, to avoid short-run issue, hot-runner system is also a necessary design.
– For plastic material with high-temperature required or with high Glass-fiber, special attention must be paid when designing and building hot runner system. Special steel and machining are required. DT-TotalSolution has very good relationship with all the big hot runner system makers like: HUSKY, Moldmaster, Synventive, YUDO, EWICON… We have been working together and keeping making new improvements for more than decade. With rich experience and knowledge to both mold and hot runner system, we can guarantee tool quality from the very beginning till mass production.
However, not every tool is suitable to be designed and built in hot runner system. There are some soft plastic material with super fast flow, it will be better to use cold runner instead. Also for some very low-volume project during prototype period, it’s more economic and suitable to use cold runner instead.
Product detail pictures:
Related Product Guide:
No matter new customer or previous client, We believe in prolonged time period and trustworthy relationship for China wholesale Stamping Factory – Hot Runner Plastic Injection Mold – DT-TOTALSOLUTIONS , The product will supply to all over the world, such as: Philippines , Madras , Yemen , Due to the stability of our products, timely supply and our sincere service, we are able to sell our products not only over the domestic market, but also exported to countries and regions, including the Middle East, Asia, Europe and other countries and regions. At the same time, we also undertake OEM and ODM orders. We will do our best to serve your company, and establish a successful and friendly cooperation with you.
